Wallpaper Installation Guide
Read the instructions carefully and follow each step.
Tools you will need
- Pencil
- Level
- Measuring tape
- Scissors
- Craft knife
- Bucket for mixing adhesive
- Mixing stick or stirrer
- Wallpaper roller or smoothing spatula
- Seam roller
- Soft sponge or cloth
Instructions
Before applying the new wallpaper, remove any old wall coverings.
Clean the wall with a soft cloth and mild, non-abrasive cleaner. Fill uneven areas with putty and apply primer. Follow the manufacturer’s recommended drying time.
The wallpaper comes in one roll and should be cut into panels along the marked lines. Do not remove the technical markings before installation — remove them only after applying. The last panel is usually narrower; cut it lengthwise, leaving a small right margin for alignment. After cutting, leave the panels in the room for 48 hours to acclimate.
Fill a clean bucket with cold water (see package for ratio), add adhesive powder while stirring, mix until smooth, and let it sit for 10 minutes before use.
To align the first strip, measure its width, mark the same distance from the left wall edge, and draw a vertical guide line with a level. Use a light pencil mark.
Apply glue directly to the wall, covering an area slightly wider than one strip.
Hang the first strip from left to right, starting with strip 1. Align it with the vertical guide and press gently with a seam roller. Avoid getting glue on the front.
Smooth the wallpaper with a spatula or roller, working from the center outward to remove air bubbles with gentle strokes.
Apply glue directly to the wall, covering an area slightly wider than the next strip.
Apply the next strip edge to edge without overlap, following the numbered order. Carefully align the pattern and press the seams gently with a seam roller or spatula.
Gently wipe off excess adhesive with a soft sponge or cloth. Avoid rubbing to prevent damage.
Repeat steps 9–11 until all wallpaper strips are applied.
Trim excess wallpaper at the top and bottom using a craft knife.
Let the wallpaper dry for 24 hours. Avoid drafts and significant temperature changes during this time.


































